如何在Ubuntu上设置kismet.conf

我在我的Ubuntu 10.04机器上安装了Kismet作为apt-get install kismet，每件事似乎工作正常。

但是当我启动它时，我看到以下错误

天命

Launching kismet_server: //usr/bin/kismet_server
Suid priv-dropping disabled.  This may not be secure.
No specific sources given to be enabled, all will be enabled.
Non-RFMon VAPs will be destroyed on multi-vap interfaces (ie, madwifi-ng)
Enabling channel hopping.
Enabling channel splitting.
NOTICE: Disabling channel hopping, no enabled sources are able to
change channel.
Source 0 (addme): Opening none source interface none...
FATAL: Please configure at least one packet source.  Kismet will not
function if no packet sources are defined in kismet.conf or on the
command line.  Please read the README for more information about
configuring Kismet.
Kismet exiting.
Done.

我按照本指南 http://www.ubuntugeek.com/kismet-an-802-11-wireless-network-detector-sniffer-and-intrusion-detection-system.html#more-1776

在kismet.conf中我怎么不清楚以下行

source=none,none,addme

至于我应该改变什么呢。

lspci -vnn显示

0c:00.0 Network controller [0280]: Broadcom Corporation BCM4312 802.11b/g [14e4:4315] (rev 01)
    Subsystem: Dell Device [1028:000c]
    Flags: bus master, fast devsel, latency 0, IRQ 17
    Memory at f69fc000 (64-bit, non-prefetchable) [size=16K]
    Capabilities: [40] Power Management version 3
    Capabilities: [58] Vendor Specific Information <?>
    Capabilities: [e8] Message Signalled Interrupts: Mask- 64bit+ Queue=0/0 Enable-
    Capabilities: [d0] Express Endpoint, MSI 00
    Capabilities: [100] Advanced Error Reporting <?>
    Capabilities: [13c] Virtual Channel <?>
    Capabilities: [160] Device Serial Number 
    Capabilities: [16c] Power Budgeting <?>
    Kernel driver in use: wl
    Kernel modules: wl, ssb

和

iwconfig显示

lo        no wireless extensions.

eth0      no wireless extensions.

eth1      IEEE 802.11bg  ESSID:"WIKUCD"  
          Mode:Managed  Frequency:2.462 GHz  Access Point: <00:43:92:21:H5:09>
          Bit Rate=11 Mb/s   Tx-Power:24 dBm   
          Retry min limit:7   RTS thr:off   Fragment thr:off
          Encryption key:off
          Power Managementmode:All packets received
          Link Quality=1/5  Signal level=-81 dBm  Noise level=-90 dBm
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:169  Invalid misc:0   Missed beacon:0

那么我该怎么做才能代替

 source=none,none,addme

我上面提到的输出？

来自Kismet自述文件

WL（Linux，Intel）

  Broadcom has released a binary version of their drivers called WL.
  These drivers are incapable of monitor mode, and cannot be used with
  Kismet.  Kismet will attempt to autodetect them and report this to the 
  user.  Users of Broadcom cards should use the b43 or b43xx in-kernel
  drivers.

所以试试吧

source=bcm4312,none,kbr0

我认为这应该有效。